To measure skins for existing boards: Most boards will not be a full 4' in height or a full 4', 6' or 8' in width because of the framing materials used in construction of new boards. To install these skins over existing boards you will want to carefully measure the inside of your existing frame from the top of the marker tray to the inside of the frame on the top of the board for your height. Now measure from the inside of the frame on the left to the inside of your frame on the right for your length. Take measurements at more than one spot in case the existing board is not square and use the smallest measurements so that your panel fits correctly. Note that custom cuts may be off by up to 1/8" so plan accordingly.
Installation: Once your new factory pre-cut panels arrive thoroughly clean the old existing surface and test fit the new panels before you remove the peel and stick backing. Remove any existing H-Bars on the existing boards and fill in any holes, etc. Carefully remove the adhesive backing without allowing any dirt or debris to attach to the back of the panel... Keep it clean! Next spray a solution of 50/50 solution of water and alcohol on the surface and on the back of the skin to retard the adhesive just a little. Align skin and press onto old surface. Start at one edge let surface make contact while smoothing out any bubbles. Roll over entire area making sure skin makes complete contact. Peel off protective film from face of skin.
For a finishing touch you may want to apply a small bead of white chalking material around the outside edge of the board to fill in any small gaps or rough edges.
Normal lead-time is about 2-1/2 weeks to ship from the factory and summer lead-times may be a little longer.
Related Products : Chalkboard Peel and Stick Panels | White Powder Coated Cover Bar | Peel and Stick Roller Application Tool | Peel-N-Stick Installation Instructions
If your order comes to you by truck you have to open and inspect your order regardless of what the outside of the carton may look like. Large objects like these can be damaged during transit and it is your responsibility to inspect your shipment on arrival. We will replace any damaged product free of charge if it is signed for as damaged upon arrival.
*If your order must ship by truck we have a shipping fee of $100.00 within the continental U.S. to your loading docks or curb side. If your board order is over $850 then you will only be charged a flat fee of $45. There is a service charge of $35.00 for "Call Ahead" service. Custom orders and graphics orders are not included in our free shipping program.
